How do you reset the security light on a 2001 Oldsmobile Alero?

How do you reset the security light on a 2001 Oldsmobile Alero?

How to Reset the Security System in Oldsmobile Aleros

1. Insert the key into the ignition.
2. Rotate the key to the “On” position. Leave the key in that position for 10 minutes.
3. Rotate the key to the “Off” position when the security warning light on the instrument panel disappears.
4. Start the car as normal.

How do you reset the computer on a 2001 Oldsmobile Alero?

Reset the Security Computer

1. Turn the key in the ignition to start the Alero. If it won’t start, leave the key in the ‘On’ position for ten minutes. All of the doors have to be closed when you do this.
2. Try to start the ignition again. Let it idle for five minutes before you put it in gear.

How can I bypass PassLock?

Thankfully this is an easy fix.

1. Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start.
2. Look at the dashboard and locate the theft system light.
3. Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.

How do I reset my GM security system?

How to Reset the Passlock System on GM Cars

1. Insert your key in the starter, start you car as you usually would and let it stall. Keep the key in the “On” position.
2. Wait until the “Theft Sys” light on your dashboard stays on without blinking. This will take approximately 10 to 15 minutes.

How do you reset a Oldsmobile Alero?

Oldsmobile Alero Oil Change Light Reset Procedures:

1. Turn ignition switch to ON position with engine off.
2. Fully depress and release the accelerator pedal 3 times within 5 seconds of turning key.
3. Change Oil lamp will flash for 2-10 seconds while it resets.
4. Once it stops flashing, the maintenance light reset is complete.

How do you program a key fob for a 2004 Oldsmobile Alero?

Press and hold both the “Lock” and “Unlock” buttons on the keypad that you would like to program. Continue to hold the buttons until the vehicle’s horn sounds two times, which will take approximately 15 seconds. Repeat this step for each additional keypad that you would like to program.

How do I reset my 2004 Alero?

2004

1. Turn ignition switch to ON position with engine off.
2. Fully depress and release the accelerator pedal 3 times within 5 seconds of turning key.
3. Change Oil lamp will flash for 2-10 seconds while it resets.
4. Once it stops flashing, the maintenance light reset is complete.

Can you disable PassLock?

The Passlock system on a Vehicles is the anti-theft system. The Passlock system uses a recognition transponder in the ignition tumbler and a computer chip in the ignition key. While you cannot remove the Passlock system, you can disable it by tricking it into thinking the Vehicles had a malfunction.

How do I permanently disable anti-theft system?

Turn the key to unlock your car door, but don’t release it. Hold the key in this position for 20 to 30 seconds. This lets the system know you have the correct key, and it can allow you to bypass the alarm system. Some vehicles recognize the key simply by turning the key back and forth in the door lock key cylinder.

How do I get my car out of anti-theft mode without remote?

How do I get my car out of security mode?

Step 1: Insert the key into the door lock. Use the side door on the driver’s side and the physical key even if there is a keyless entry system on the car. Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in the position.

How do I reset my anti theft system?

Exit the car with all doors closed and the windows rolled up. Also close and any rear doors such as the trunk, rear hatch and front hood. Lock the car using the drivers side lock and walk away from the car at least ten feet. Wait for fifteen minutes and unlock the door, this should reset the security system.

How do I Turn Off PassLock on my car?

The other option is to turn the PASSLOCK off. Use the radio to do this. Key on, press volume till readout says SETTINGS then scroll to the Security to toggle off by pressing reset (watch YOUTUBE). I personally see no sense of having no security system so try the RELEARN method.

How to permanently disable the PassLock II system?

You will notice that on the side closest to the front seats, the plug is pretty much split in two. We will be working with the right side of this plug. We are looking for the wire that is White with a BLUE stripe. It will be with other wires that are white/colored stripe. Step Thee: Cut this wire in half, and electrical tape both ends.

How to reset PassLock 3 on a Chevy?

Passlock III reset procedure, reset security system on chevy, buick, oldsmobile, cadillac, pontiac, saturn, hummer. Passkey III Reset procedure.

How do I Reset my PassLock security system?

If it starts and runs normally, the relearn is complete. If you need to program additional keys, 12. Turn the key to OFF. 13. Insert the next key. Turn it to ON within 10 seconds of removing the previously used key. 14. Wait for the SECURITY light to turn off. That may happen quickly.