How do you reset the oil light on a Rancher 420?
Turn the ignition on without starting the engine. Press and hold the trip meter select button. Press and hold the “Reset” button. Release both buttons after the oil light disappears.
How much oil does a Honda 420 Rancher hold?
PRO TIP: Honda says the oil capacity of the Rancher 420 is 3 quarts, but we found that can be a little too much. Pour in 2.5 quarts, replace the fill cap, run the engine for a couple of minutes, and then check the level.
How do you reset a Honda Rancher computer?
hold both the up and down shift buttons and turn the switch on. then release and press up – down – up , move the throttle lever from fully closed to fully open and then back to fully closed. this all has to be done pretty fast and should here the control motor cycle.
How much oil does a 2013 Honda 420 take?
3 Quarts of Honda GN4 10W-30 4-Stroke Motorcylce Oil.
What is an angle sensor on Honda Rancher?
To reset the system on the 99 turn the key switch on and hold both up and down shift buttons for 3 to 8 seconds. What does angle sensor do on ATV? they control the angle of the shifting shaft when it shifts gears.
How to turn off the oil change light?
To reset the indicator on the 420, press and hold hr/od/trip select button. Turn the ignition switch to on and hold for more than 5 seconds. The indicator will disappear. Thanks, maybe I misrepresented my wheeler…it is the TRX400FA. I actually FOUND the manual.
How to reset the maintenance indicator on a Honda rancher?
How to reset the maintenance indicator, Honda Rancher 420: Press and hold the mode button and turn the ignition switch to ON. Continue to hold the mode button for 2 seconds and the maintenance indicator will flash twice.
How to turn off oil change light on Honda trx400fa?
To reset the indicator on the 420, press and hold hr/od/trip select button. Turn the ignition switch to on and hold for more than 5 seconds. The indicator will disappear. Thanks, maybe I misrepresented my wheeler…it is the TRX400FA.