Table of Contents
Where is the coolant temperature sensor located?
Usually, the location of the coolant temperature sensor will be located directly behind the coolant pipe. In most modern cars and vehicles, this is present behind the right cylinder head that is located right underneath of the air intake pipe.
What are the symptoms of a bad temperature coolant sensor?
Symptoms of a bad or failing coolant temperature switch (sensor)
- Poor fuel economy. One of the first symptoms associated with a problem with the coolant temperature sensor is poor fuel economy.
- Black smoke from engine.
- Overheating engine.
- Check Engine Light comes on.
What happens if you unplug the coolant temp sensor?
What Happens If You Unplug The Coolant Temp Sensor? Unplugging the engine coolant sensor while the car is running will likely cause the engine to stumble and run rough. The engine will run rich, so you’ll smell raw gas, and you may see black smoke from the tailpipe.
Can I drive my car with a bad coolant temperature sensor?
It is possible to drive a vehicle with a faulty coolant temperature sensor as the management system defaults to a static reading. A vehicles coolant sensor is a critical component used by the engine management system. It directly effects, cooling and fueling of the engine and therefore effects how the engine performs.
How do you check a coolant temperature sensor?
If you have a new sensor on hand and want to check it, you can do this easy test. Connect the black lead of the meter to the body of the cold sensor and the red to the terminal. You should have a reading of approximately 2000 ohms. Check the warm sensor in your engine.
Can you drive a car with a bad coolant temperature sensor?
What causes a coolant temperature sensor to fail?
One of the common problems is; when the sensor has a, poor connection inside or in the connector. This causes interruptions in the signal to the (PCM) and the (PCM) sets the fault. In some vehicles, symptoms of this problem show up as, erratic readings of the temperature gauge.
Can you drive with a bad coolant thermostat?
If it is failed in a closed position then you cannot really drive it with the thermostat broken, as the engine would overheat. This however will not generally have any impact on the ability to drive the car, at least if you let it warm up before you start driving.
How much does it cost to replace a coolant temperature sensor?
The average price for an engine temperature sensor replacement is between $150 and $193. Labor costs are between $82 and $105 while parts are between $66 and $88. Taxes and fees aren’t included in the estimate.
Is there a fuse for coolant temperature sensor?
There isn’t one per se. There will be a fused wire with voltage to the instrument cluster (your owners manual should indicate which fuse), but the temperature sensor is providing a variable “resistance to ground,” which the temperature gauge in the dash is reflecting.
Can you drive with a bad temperature sensor?
What causes a coolant temperature sensor to go bad?
The engine coolant temperature sensor is usually located on the engine block or cylinder head . It is often installed on a plastic hose on the coolant’s inlet. Different brands and car manufacturers have different ways of placing the coolant temperature sensor depending on the car design.
What are the symptoms of a bad coolant temperature sensor?
Another symptom of a problem with the coolant temperature sensor is an overheating engine. The coolant temperature sensor can also fail in a manner that causes it to send a permanently hot signal. This can cause the computer to incorrectly compensate for a lean signal, which can result in overheating, and even misfires or engine ping.
What does a bad coolant temperature sensor do?
If the coolant temperature sensor goes bad it can send a false signal to the computer and throw off the fuel and timing calculations. It is not uncommon for the coolant temperature sensor to fail and send a permanently cold signal to the computer.
What is the function of a coolant temperature sensor?
The coolant temperature sensor, also known as the coolant temperature switch, is an engine management system sensor that is used to monitor the temperature of the engine’s coolant. Most coolant temperature sensors operate using electrical resistance to measure the temperature of the coolant.