Table of Contents
How do you fix a CD player that wont read discs?
Unplug the power cord of the CD player from the AC outlet for 30 seconds. Plug the power cord back into the AC outlet. Turn on the CD player and attempt to play the disc. If the issue is still not resolved, remove the disc and unplug the power cord from the AC outlet.
Why is my Kenwood CD player not working?
If the unit does not seem to be working right, try pressing the reset button first. If that does not solve the problem, consult your Kenwood dealer. Press the reset button if the Disc auto changer fails to operate correctly. Normal operation should be restored.
Why is my car not reading my CD?
This is commonly caused by dirty or damaged tracks on the disc. Before assuming that the problem is with the player, test a few newer CDs and see if the skipping behavior continues. If it doesn’t, the the problem is the disc and you’ll need to look into cleaning or repairing the disc so that it can play normally again.
Why would a CD player stop working?
A scratched or damaged disc is often the culprit and not the player. Use a newer disc if possible to ensure the condition is pristine. If the problem persists with the new disc, remove all discs and run a power cycle to reset the player. Remove any batteries or unplug it to drain the power.
What do you do if your CD won’t play?
The Compact Disc (CD) Won’t Play
- Make sure that the disc is inserted correctly with the label side up.
- Use a soft, dry cloth to clean the disc.
- Reinsert the disc, and then press the PLAY button to see if the disc plays.
- For disc players with a HOLD switch, make sure that the switch is set to the OFF position.
How do I troubleshoot my Kenwood car stereo?
Kenwood Car Stereo Troubleshooting
- Power Problems. Check to make sure the power button on the Kenwood car stereo is pressed in and the light is on.
- CDs Don’t Play Correctly.
- Hands-Free Talking Function.
- Error Messages.
- N/A Device Message.
Why does my CD player stop and start?
If a CD is skipping, first ensure that the disc is working properly by checking to see if it plays on another device. Some common problems include: broken parts in the device, physical damage to the CD player, dirt within the player or, most commonly, damage to the lens.
Where is the reset button on a Sony CD player?
Sony CD players have a Reset button located on the front of the device.
- Turn the player on, whether by plugging it into a power outlet, or simply running it on battery power.
- Press the “Reset” button using a small, pointed object, such as the pointed end of a pencil or pen.
Is it possible to troubleshoot a Kenwood CD player?
Kenwood CD players are easy to troubleshoot. What might seem like a malfunction is often just a case of mis-operation, or settings not being specified correctly. In particular, take into account that CDs can get scratched or suffer heat damage in hot cars. It’s always a good idea to run through some troubleshooting steps before calling for service.
What does TOC error on Kenwood CD player mean?
“TOC Error” means either no disc has been loaded into the magazine, the disc is upside down, or the disc is badly scratched. Patrick Nelson has been a professional writer since 1992.
Why is my compact disc player not playing?
The Compact Disc (CD) player will not play a disc. Follow this procedure to troubleshoot if the CD player will not play a disc. Ensure the CD player is plugged into a working AC outlet. IMPORTANT: If the CD player is plugged into an AC outlet that is controlled by a light switch, ensure that the switch is in the ON position. Turn on the CD player.
What to do when your CD player won’t play?
Make sure the disc is loaded into the proper slot. Eject the magazine from the CD changer and check the number for the disc. Clean the CD if the sound skips when an audio file is being played. If that doesn’t work, there may be a problem with the recording itself, while it was being transferred to the disc. Try re-recording the file to a new disc.